Table of Contents
Advertisement
6. Remove the dust cover from the fiber input location in the projector and ensure the knurled
ring and locking pin are both rotated counterclockwise.
7. To remove the top clamp from the fiber strain relief, remove the four screws.
8. Feed the fiber optic cable with the fiber connector dust cap attached on the tip through the
fiber strain relief.
9. Remove the dust cap from the end of the fiber optic cable and store it in the safety cover.
10. To secure the fiber connector dust cap inside the safety cover, tighten the screw.
11. Gently slide the fiber optic cable into the fiber input.
Christie Eclipse Installation and Setup Guide
020-103331-01 Rev. 1 (04-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
Installation and setup
42
Advertisement
Table of Contents
