Adjusting Vertical Boresight - Christie Eclipse Installation And Setup Manual

3. Loosen the horizontal lock screw (A).
4. Extend the lens focus (B) completely.
5. Adjust the focus using the Focus knob to retract the lens.
Watch the image at the left edge of the screen until it comes into focus. If the entire screen is
in focus, proceed to step 7.
6. Continue retracting the lens.
a) If the right side of the image comes into focus before the lens is completely retracted,
adjust the horizontal boresight bolt (C) to balance the left and right edges.
b) If the right side of the image fails to focus, adjust the horizontal boresight bolt (C)
7. When both sides appear equally blurry, adjust the offsets to re-center the image.
8. Repeat steps 1 to 6 until both sides of the image are focused.
9. Tighten the lock screw (A) and the lens mount stabilization screw (D) to maintain the
adjustments.
10. Check the boresight again.
11. Adjust vertical boresight, if required.
12. To calibrate the lens motors, select Menu > Configuration > Calibrate Lens Motors.

Adjusting vertical boresight

Boresight adjustment balances the tilt of the lens mount to compensate for screen-to-projector tilt.
Warning! If not avoided, the following could result in death or serious injury.
• UV EXPOSURE! Protective UV safety glasses with side shields and Christie approved protective
safety clothing must be worn when performing optical adjustments or servicing the product.
• EXTREME BRIGHTNESS! Do not place reflective objects in the product light path.
Caution! If not avoided, the following could result in minor or moderate injury.
• Do not look directly into the lens when the light source is on. The extremely high brightness can
cause permanent eye damage.
• Adjust boresight with low light levels from a single laser module.
Christie Eclipse Installation and Setup Guide
020-103331-01 Rev. 1 (04-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
Installation and setup
54