Connecting An Hdmi Video Source - Christie Eclipse Installation And Setup Manual

ID Port
A HDMI
B SDI
C DisplayPort
D Christie Link
E SDVoE
F USB -C
G USB 3.0-A
H Ethernet
I 3D Sync In/3D Sync Out
J Christie Link
K RS232
L GPIO
M Audio Out
N HDBaseT
O Wired keypad

Connecting an HDMI video source

For the projector to accept digital video data from HDMI sources, plug the HDMI source directly into
the Video Input panel.
The input configurations listed below are supported.
Input configuration
One-Port
Christie Eclipse Installation and Setup Guide
020-103331-01 Rev. 1 (04-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
Connecting devices and establishing communication
Description
Accept digital video data from HDMI 2.0 input
with HDCP 2.2 and 1.4 support.
Accepts digital video data from 12G, 6G, 3G, and
HD SDI sources.
Accepts digital video data from DisplayPort 1.2
input with HDCP 1.3 support.
Accept digital video data from QSFP+ 40 GB
optical Christie Link input.
Accept digital video data from SDVoE input.
Connects a USB-C flash drive that has been
formatted with a FAT32 file system. Can be used
for upgrades, backups, restores, and
interrogators.
Connects a USB flash drive that has been
formatted with a FAT32 file system. Can be used
for upgrades, backups, restores, and
interrogators.
Ethernet, and network connection for remote
control. 10/100/1000 Base-T Ethernet x 1
ruggedized connector.
Supported for 3D-enabled projectors.
Currently not supported for Christie Eclipse.
Reserved for future use.
Sends/receives Christie serial commands using a
standard RS232 serial cable.
Provides a method for controlling the projector
using electrical signals.
Reserved for future use.
Used for communication with the IPG laser rack
rather than for accepting HDBaseT signals.
Physically connects a remote control to the
projector.
Description
Enables connection of one HDMI cable.
Default SDVoE
enabled enabled
X X
X
X
X X
X
X X
63