Christie Eclipse Installation And Setup Manual page 79

Channel Name
3 Shutter
4 Lens Shift Enable
5 Zoom (Coarse)
6 Zoom (Fine)
7 Focus (Coarse)
8 Focus (Fine)
9 Lens Horizontal
Position (Coarse)
10 Lens Horizontal
Position (Fine)
11 Lens Vertical Position
(Coarse)
12 Lens Vertical Position
(Fine)
13 Input
Christie Eclipse Installation and Setup Guide
020-103331-01 Rev. 1 (04-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
Connecting devices and establishing communication
Description
0 to 85 = Closes the
shutter (black screen)
172 to 255 = Opens the
shutter (live video)
0 to 171 = Disables lens
shift
172 to 255 = Enables lens
shift
0 = Smallest image
possible (0%)
255 = Largest image
possible (100%)
0 = 0%
255 = 100%
0 = Full left position (0%)
255 = Full right position
(100%)
0 = Full lower position
(0%)
255 = Full upper position
(100%)
1 to 80 = Input index
86 = Load
91 to 170 = Additional
input indices
171 = Execute
Suggested Notes
starting
position
255 Christie recommends setting
this channel to 255 prior to
powering up the projector so
it is consistent with the
shutter state after the
projector is fully on.
— Locks all lens motors.
128
• Locked by the Lens Shift
Enable channel.
• Scaled as a percentage of
the total control range.
• A 250 ms delay exists
before sending this
channel to the projector.
128
• Locked by the Lens Shift
Enable channel.
• Scaled as a percentage of
the total control range.
• A 250 ms delay exists
before sending this
channel to the projector.
128
• Locked by the Lens Shift
Enable channel.
• A 250 ms delay exists
before sending this
channel to the projector.
128
• Locked by the Lens Shift
Enable channel.
• A 250 ms delay exists
before sending this
channel to the projector.
0 To change inputs, send the
following sequence:
Load > Input index > Execute
Channel 1 slider lock can be
used if a keypad is not
available for the input
selection.
79