Christie Eclipse Installation And Setup Manual page 36

Table of Contents

1. On the laser rack, install either the J33 connector with cable provided with the laser rack or the

J33 connector provided with the projector.

•

J33 terminal block 1—Install the J33 terminal block by tightening the two screws.

•

J33 terminal block 2—Install the J33 terminal block with the integrated cable (in the same

location as shown above for the J33 terminal block 1) by tightening the two screws and

proceed to step 2.

Terminal block 2 shown below with cable:

Terminate all wires or the projector may not operate.

2. To make use of the remote operation feature (J33 terminal block option 2), terminate the wires

for correct operation.

Each wire has a label indicating what pin it is connected to.

a) Ensure pins/wires 17 to 20 and 18 to 19 are closed or the projector will not operate in the

local or remote position.

These pins can be connected to a remote E-stop button and/or the remote fire disconnect

and/or each circuit closed if the remote E-stop is not required. Keep each circuit isolated

from other circuits.

b) Wire the automation device to provide the ability to maintain a closed circuit between the

J33 pins 8 and 9 when the equipment is operating.

Christie Eclipse Installation and Setup Guide

020-103331-01 Rev. 1 (04-2022)

J33 terminal block 1

shown here with the

location of the

mounting screws

indicated with the red

arrows

Terminal block 2 shown

here with cable

Installation and setup

Table of Contents