Table of Contents
Advertisement
5. Once the projector is in standby, on the projector keypad or the projector remote, press and
hold the power
The projector can also be turned on using the web user interface. After a few seconds, the
projector moves to the on state, causing the yellow light on the laser illumination source to
turn off. The laser is ready to be turned on but no illumination occurs until the green button is
pressed and the lasers have warmed up.
6. Turn on the lasers:
•
Local operation— On the laser illumination source, press the green Start button (D). This
illuminates the green (button) light and the yellow light goes out.
•
Remote operation—From the automation device, turn on the lasers with a 500ms contact
closure of circuits 21/22 on the J33 wire. This illuminates the green (button) light and the
yellow light goes out.
The two Emission status indicators (E) turn red. When the lasers are warmed up and the
projector is ready, the shutter automatically opens and you can display an image (use test
pattern if no source image is connected).
Christie Eclipse Installation and Setup Guide
020-103331-01 Rev. 1 (04-2022)
Copyright
©
2022 Christie Digital Systems USA, Inc. All rights reserved.
button until you hear a beep.
Installation and setup
48
Advertisement
Table of Contents
