Projector Led Shutter Indicators; Adjusting The Image; Aligning The Image - Christie Eclipse Installation And Setup Manual

LED State
Red Solid
Flashing
Off

Projector LED shutter indicators

Identify the shutter LED state colors and meaning.
LED
Solid magenta
Off

Adjusting the image

Ensure the content displayed by the Christie Eclipse has a high quality appearance by manipulating the
image settings.

Aligning the image

Follow these steps to align the image.
1. Set RGB to 100% and master slider to 20%.
a) From the side panel display, select MENU > Configuration > Light & Output Settings.
b) Set RGB to 100%.
c) Set the master slider to 20%.
2. Turn on the lasers.
3. Open the Hawkeye software and connect to the projector IP address.
4. Open the Alignment tab and select the IOS alignment pattern.
5. On the 2K light engine, complete the following:
a) Loosen four screws and straighten the adjust integrator.
b) Adjust the 2K light engine fold mirror using the two visible set screws.
Do not adjust the third set screw.
c) Fill the entire screen with light.
d) Loosen the set screws for the 2K light engine IOS zoom and focus the image.
e) Make any necessary adjustments.
6. On the 4K light engine, complete the following:
Christie Eclipse Installation and Setup Guide
020-103331-01 Rev. 1 (04-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
Error in
standby
Error
AC off
State
Shutter closed
Shutter open
Description
Projector is in standby. An error exists that
prevents the projector from starting up.
An error with the projector exists during startup,
cool down, or when the light source is off. Projector
will proceed to shut down.
The AC power is off.
Description
The shutter is closed.
In standby, the shutter is always automatically closed and
the magenta light is muted.
The shutter is open.
Installation and setup
51