Performing Initial System Start-Up - Christie Eclipse Installation And Setup Manual

Performing initial system start-up

Learn how to turn on all components of the Christie Eclipse system for the first time: chiller, laser
illumination source, and projector head.
Warning! If not avoided, the following could result in death or serious injury.
• SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and current, as specified on the license label.
Never run the laser illumination source without the cooling system already running. The chiller must
be the first item turned on before power is applied to the laser rack and kept operating until after the
AC lockout/switch is rotated to the off position.
1. Verify the coolant lines are connected correctly.
2. Fill the chiller reservoir with an approved coolant.
3. Turn on the chiller, set the temperature to between 19°C (66°F) to 22°C (71.6°F).
For more information on how to turn on the chiller, refer to the chiller's product
documentation.
4. Check the coolant level in the reservoir and hoses and top up the coolant as required.
5. Check that no leaks exist in the system.
6. Allow the chiller to run until the system is operating with no new bubbles entering the
reservoir. Add additional coolant as necessary.
This typically takes approximately 5 to 10 minutes.
7. Power on the laser illumination source:
• Local operation— Rotate the main AC lockout/switch (A) to the ON position and rotate the
Power key (B) clockwise to the ON position.
• Remote operation—Rotate the main AC lockout/switch (A) to the ON position and rotate
the Power key (B) counter clockwise to the REM (remote) position. From the automation
device, turn on the laser illumination source (by closing circuits 8/9 from the J33 wire).
The Interlock status indicator (C) on the laser illumination source turns yellow.
8. On the projector beside the AC inlet, move the AC breaker/switch to the ON position.
The projector boots into standby mode after approximately 30 seconds. If the projector is
properly connected, the light on the back of the projector should be yellow.
Christie Eclipse Installation and Setup Guide
020-103331-01 Rev. 1 (04-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
Installation and setup
45