B&R Automation Panel 5000 User Manual page 158

Installation and wiring
5.5.8 Uninstalling the IP54 VESA mounting unit
Notice!
The following note must be observed when using a PPC2200:
The heat pipe can reach an elevated temperature. It is therefore recommended to wait some time after
switching off before opening the cover.
The following requirements must be met:
• All connected cables must be disconnected.
• The Automation Panel must no longer be installed on the VESA bracket.
1. To uninstall the IP54 VESA mounting unit, perform the installation in reverse order (see
VESA mounting unit" on page
158
159).
"Installing the IP54
Automation Panel 5000 User's manual V2.11