HTTP Server Commands
The commands in this section are listed in the order in which they might be used.
Command Syntax
Description
Default Value
Success
Error
Command Syntax
Description
Default Value
Success
Error
Command Syntax
Description
Default Value
Success
Error
Command Syntax
Description
Default Value
Success
Error
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
set ip http-page <default/serial>
This parameter is used by the http server to host the default HTML index or
host-defined http-serial-S0 HTML page.
Default
OK
1. Too few arguments
"Usage: set ip http-page <default/serial>
Type set ip http-page ?"
2. Invalid string
Type "set ip http-page ?"
set ip http <enable/disable>
This enables the http server on the MultiConnect IP to listen on Port 80.
Disable
OK
1. Too few arguments
"Usage: set "ip http <enable/disable>
Type 'set ip http ?' for more information"
2. Invalid string
"ERROR: Invalid string
Type 'set ip http ?' for more information"
set ip http-port <port>
Sets the HTTP server to listen on the specified port.
80
OK
1. Too few arguments
"Usage: set ip http-port <port>
Type set 'ip http-port ?' for more information"
2. Invalid port number
"ERROR: Invalid port number
Type set 'ip http-port ?' for more information"
set device-parameter P<n> <value>
where n = 0 to 99.
Sets the value of the parameter from the host/serial device.
Value in the default parameter list file uploaded through TFTP.
OK
1. Too few arguments
"Usage: set device P<n> <value>
Type 'set device P<n> ?' for more information"
2. Invalid string
"ERROR: Invalid string
Type 'set device P<n> ?' for more information"
Chapter 4 – Command Line Interface (CLI)
HTTP Server Commands – Setup
47