Table of Contents
Advertisement
Multi-Tech CallFinder Quick Start
there are any). All incoming calls made to activated
DID numbers for which no PBX extension has been
assigned will go to the party listed in the second row.
Typically an operator (or administrator) might handle
such calls. However, any name can be entered in
this second row.
ii.
Click on Update in the second row. The message
"Success: [name] was updated" will appear above
the Phone Book list.
7. Setting Up the Mail Server
The CallFinder uses a mail server to send, by email, call log reports
to the administrator. An email is also sent to the administrator each
time the CallFinder is powered up. In all cases, you must specify the
address of the mail server and the email address of the
administrator. Some email servers require authentication before
allowing the CallFinder access. In these cases, the CallFinder unit
must be assigned a Server User Name and a password. If the mail
server does not require authentication, the bottom row of SMTP
Configuration fields ("Server User ID," "Password," and "Retype
Password") must be left blank.
a. In the CallFinder Administration screen, go to the SMTP
Configuration fields.
b. Fill in the network IP address or domain name of your mail
server.
c. Enter the email address of the administrator (the party that you
want to receive call log reports).
Server Installation
15
Advertisement
Table of Contents
