Multitech MultiConnect MTS2SA-T User Manual page 117

Command: +PSS
Description:
Defined Values:
Result Codes:
Report Commands:
Command: –QCPC
Description:
Result Code:
Command: –QCPS
Description:
Defined Values:
Result Codes:
Report Commands:
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
Chapter 10 − Modem Mode AT Commands, S-Registers, and Result Codes
Use Short Sequence
Causes a calling modem to force either a V.92 short or full startup sequence as
defined by the +PQC command on the next and subsequent connections.
+PSS0 The modems decide whether or not to use the short startup
procedures. The short startup procedures can only be used if enabled
by the +PQC command. (Default.)
+PSS1 Reserved.
+PSS2 Forces the use of the full startup procedures on the next and
subsequent connections independent of the setting of the +PQC
command.
OK 0 - 2 in V.92 Mode (+MS=V.92)
ERROR
+PSS? Reports Selected Values.
+PSS=? Reporting Supported Range of Parameter Values
Force Full Startup Procedure on Next Connection
Causes the modem to use full startup procedures on the next connection attempt
regardless of the setting of the +PQC command. After this attempt, the modem will
select the startup procedure as defined by the +PQC command. If a shortened
startup procedure is enabled by the +PQC command, then the quick connect profile
will also be updated on the next connection attempt.
OK In V.92 Mode (+MS=V.92)
ERROR
Enable Quick Connect Profile Save
This command controls whether or not the modem will save the generated quick
connect profile.
-QCPS0 Do not allow the quick connect profile to be saved.
-QCPS1 Allow the quick connect profile to be saved. (Default.)
OK in V.92 Mode (+MS=V.92) and quick connect is enabled (+PSS = 0)
ERROR
-QCPS? Reports Selected Value(s).
-QCPS=? Reports Supported Range of Parameter Values.
117