Multitech MultiConnect MTS2SA-T User Manual page 29

Command Syntax
Description
Default Value
Success
Error
Command Syntax
Description
Default Value
Success
Error
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
set serial [s0] auto-dialin <enable/disable>
Enables/disables the device port to Internet connectivity for the serial port
S0. This command is valid only for device port S0
Disabled
OK
1. Too few arguments
"Usage: set serial s0 auto-dialin <enable/disable>
Type 'set serial s0 auto-dialin ? for more information"
2. Multiple matches
auto-dialin
auto-dialin-ipaddress
auto-dialin-port
3. Invalid string
"error: Invalid string
Type 'set serial s0 auto-dial-in ? for more information"
4. If "set serial s1 auto-dialin <enable/disable>" is given
"error: Command not supported on the modem port s1"
set serial [s0] auto-dialin-ipaddress <ipaddr>
Specifies the auto dial-in IP address.
Note: When a connection is established from serial, a session is
established to the IP address mentioned above.
This command is valid only for device port S0.
NULL
OK
1. Too few arguments
"Usage: set serial s0 auto-dialin-ipaddress <ipaddr>
Type 'set serial s0 auto-dialin-ipaddress ? for more information"
2. Multiple matches
auto-dialin
auto-dialin-ipaddress
auto-dialin-port
3. Invalid IP Address
"error: Invalid IP address
Type 'show serial s0 auto-dialin-ipaddress ? for more information"
4. If "set serial s1 auto-dialin-ipaddress 192.168.2.2" is given
"error: Command not supported on the modem port s1"
Chapter 4 – Command Line Interface (CLI)
Serial Commands – Setup
auto-dialin-protocol
auto-dialout
auto-dialout-port
auto-dialin-protocol
auto-dialout
auto-dialout-port
auto-dialout-protocol
auto-dialout-protocol
29