Setting Passwords; Deleting Users; Notes; Ppp Configuration - Multitech MultiConnect MTS2SA-T User Manual

Setting Passwords

Upon successful execution of this command, the MultiConnect IP will return an OK or an error
message.
Command:
Example:

Deleting Users

Upon successful execution of this command, the MultiConnect IP will return an OK or an error
message.
Command:
Example:

Notes

•
PPP is enabled on the modem port
•
PPP interface is the IP-enabled interface in MultiConnect IP
•
All IP-enabled services can be used only after the PPP link is up with an IP Address
•
In the event of a PPP link down, SMTP and POP3 requests can trigger the PPP link
establishment and termination

PPP Configuration

PPP Interface Related Parameters
•
Enable PPP
•
Enable/Disable Authentication and Authentication Type
•
Configure user name/password for remote peer to authenticate
•
Configure IPCP mode
•
Configure local and remote IP addresses
•
Enabling/Disabling compression
•
Configure the compression algorithm
Serial Interface Related Parameters
•
Configure the Connect Type
•
Configure the modem settings
•
Configure the dialing trigger mode
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
# user password <username> <password>
# user password user1 user1
OK
# user delete <username>
# user delete user1
OK
Chapter 11 – Point-to-Point Protocol
133