Multitech MultiConnect MTS2SA-T User Manual page 31

Command Syntax
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
Succeseri
set serial [s0] auto-dialin trig-mode <char/ dtr/ dtr-char/ none>
Description This mode is applicable only when auto dial-in is enabled on the serial port
S0. This command is valid only for device port S0.
Parameter Description
char
Initiate a session (Telnet) to the auto-dialin-ipaddress, only on a reception
of a character on the serial port S0.
dtr
Initiate a session (Telnet) to the auto-dialin-ipaddress, only on seeing a
DTR signal on the serial port S0
dtr-char
Initiate a session (Telnet) to the auto-dialin-ipaddress, either on reception
of a character (OR) seeing the DTR signal on the serial port S0.
none
Initiate a Telnet session to the auto-dialin-ipaddress on module boot-up.
Default Value dtr-char
Success OK
Error 1. Too few arguments
Too few arguments. Possible argument(s) are
2. Invalid string
"Invalid string "string"
Valid arguments are
3. If "set serial s1 auto-dialin trig-mode <char/dtr/dtr-char/none>" is given
"error: Command not supported on modem port s1"
Chapter 4 – Command Line Interface (CLI)
char dtr-char
dtr none
char dtr-char
dtr none
Serial Commands – Setup
31