Table of Contents
Advertisement
Windows 98/95 Dial-Up Networking
Windows 98/95 includes a remote-node client called Dial-Up Networking (DUN).
To install and operate Dial-Up Networking
1. Insert the Windows 98/95 CD-ROM into the CD ROM drive.
2. In Windows 98/95, click Start | Settings | Control Panel | Add/Remove Programs.
3. Click the Windows Setup tab.
4. In the Components list, select Communications; then click Details.
5. In the Components list, select Dial-up Networking; then click OK. Your client
6. When the installation is complete, reboot the client computer.
7. Double-click the My Computer icon.
8. Double-click the Dial-Up Networking icon.
9. Double-click the Make New Connection icon. When the connection is made, your
For additional information on Dial-Up Networking, see Windows 98/95 Help.
AT Commands
You can configure the MTA128ST-USB by using AT commands, just as you would
configure an analog modem. Use this method if you prefer to work with AT commands or
if you have a special requirement not addressed by either of the configuration utilities.
Using AT Commands to Configure the MTA128ST-USB
1. Connect the MTA128ST-USB to the USB port on your PC.
2. Turn on the MTA128ST-USB. Once the drivers are installed, Windows 98/95 will
3. Start a data communication program and select the COM port where the MTA128ST-
4. Referring to the Configuration section, enter the desired AT commands in the
5. When you finish making changes, use the &W command to save your new
6. Quit the data communications program.
For more information on AT commands, refer Chapter 4.
MTA128ST-USB
computer accesses the Windows 98/95 CD-ROM.
Windows 98/95 client is ready to dial up a remote access server.
automatically detect the presence of the MT128ST-USB and activate the associated
COM port.
USB is connected.
terminal window of the data communications program.
configuration and to select it to automatically load when the MTA128ST-USB is
turned on.
Chapter 3 - Software Installation and Configuration
25
Advertisement
Table of Contents
