General Setup Commands - Multitech MultiConnect MTS2SA-T User Manual

General Setup Commands

General setup of a MultiConnect IP is port-independent (physical S0, S1 etc.). The following command
set is used to set the global configuration of MultiConnect IP.
Command Syntax
Description
Default Value
Success
Error
Command Syntax
Description
Default Value
Success
Command Syntax
Description
Default Value
Success
Command Syntax
Description
Default Value
Success
Error
Command Syntax
Description
Default Value
Success
Error
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
dialout serial s0
Manual Telnet dialout (Internet-to-serial connectivity).
Invoked from the command shell.
NA
OK
1. Too few arguments
"Usage: dialout serial <serial port>
Type 'dialout ?' for more information"
2. Invalid argument
Possible argument(s) are: Serial
1. When invoked from Serial Shell
This command is not supported through serial dial-in
Exit
Exits the command parser, unlocks the configurations, terminates session.
NA
OK
Help
Provides the first level of commands in MultiConnect IP.
NA
OK
restore default-config
Restores the factory defaults.
Note: All previous configurations will be lost upon invoking this command.
The changes are made permanent only if save config is invoked.
NA
OK
1. Too few arguments
"Possible arguments are default-config and session
2. Invalid argument
Invalid argument "invalid string"
Valid arguments are default-config and session
restore session
On Telnet dialout, the control is transferred to the command parser passing
the escape sequence "+++ inet". Invoking "restore session" would resume
the Telnet dialout exiting the command parser.
NA
OK
1. Too few arguments
Possible arguments are default-config and session
2. ERROR: Session not opened
Chapter 4 – Command Line Interface (CLI)
General Commands – Setup
16