Multitech MultiConnect MTS2SA-T User Manual page 96

Command: &Zy=x Store Telephone Number (Not available in V.22bis)
Values: y = 0–3
x = Dialing command
Default: None
Description: Stores up to four telephone numbers and each telephone number dial string can contain up
to 31 digits (requires 256-byte NVRAM installed).
Command: \Bn Transmit Break to Remote
Values: n = 0–9 in 100 ms units
Default: 3
Description: In non-error correction mode, the modem will transmit a break signal to the remote modem
with a length in multiples of 100 ms according to parameter specified. If a number in excess
of 9 is entered, 9 is used. The command works in conjunction with the \K command.
In error correction mode, the modem will signal a break through the active error correction
protocol, giving no indication of the length.
Command: \Kn Break Control
Values: n = 0–5
Default: 5
Description: Controls the response of the modem to a break received from the computer, the remote
modem, or the \B command. The response is different for each of three different states. The
parameter value, if valid, is written to S40 bits 3, 4, and 5.
Data Mode. The modem receives a break from the computer:
\K0
\K1
\K2
\K3
\K4
\K5
Data Mode. The modem receives a break from the remote modem:
\K0
\K1
\K2
\K3
\K4
\K5
Online Command Mode. The modem receives a \Bn command from the computer:
\K0
\K1
\K2
\K3
\K4
\K5
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
Chapter 10 − Modem Mode AT Commands, S-Registers, and Result Codes
Enter online command mode, no break sent to the remote modem.
Clear data buffers and send break to the remote modem.
Same as \K0 .
Send break immediately to the remote modem.
Same as \K0 .
Send break to the remote modem in sequence with the transmitted data.
Clear data buffers and send break to the computer.
Same as \K0 .
Send break immediately to the computer.
Same as \K2 .
Send break to the computer in sequence with the received data.
Same as \K4 .
Clear data buffers and send break to the remote modem.
Same as \K0 .
Send break immediately to the remote modem.
Same as \K2 .
Send break to the remote modem in sequence with the transmitted data.
Same as \K4 .
96