Ppp Interface Related Parameters; Enabling/Disabling Authentication; Authentication Type - Protocol; User Name & Password For Remote Peer Authentication - Multitech MultiConnect MTS2SA-T User Manual

PPP Interface Related Parameters

Enabling/Disabling Authentication

This command enables or disables a PPP Authentication session . If Authentication is enabled,
then the authentication protocol, the user name, and password should also be set.
Command:
Example:

Authentication Type - Protocol

This command sets the Authentication type.
Command:
Example:
User Name & Password for Remote Peer Authentication
This command sets the user name with which the remote server will authenticate. If
authentication is disabled, this need not be configured.
Command:
Example:

IPCP Mode

This command sets the IPCP mode.
Command:
Examples:

Show Commands

This command allows you to view the PPP configuration settings.
Command:
This command allows you to view the PPP logical link status
Command:
Example:
This command allows you to view the PPP link IP address
Command:
Example:
Multi-Tech Systems, Inc. MultiConnect Serial-to-Serial Adapter User Guide (S000354A)
# set ppp [interface] authentication <enable/disable>
# set ppp ppp0 authentication enable
OK
# set ppp [interface] auth-type <pap/chap/pap-chap>
#set ppp ppp0 auth-type pap
OK
# set ppp [interface] username
# set ppp [interface] password
# set ppp ppp0 username user1
OK
#set ppp ppp0 password user1
OK
# set ppp [interface] ipcp-mode <client-only/client-or-lan>
# set ppp ppp0 ipcp-mode client-only
OK
When ipcp-mode is set to client-only, the local and remote ip addresses are set
to 0.0.0.0 automatically
# set ppp ppp0 ipcp-mode client-or-lan
OK
When ipcp-mode is set to client-or-lan, the local and remote ip addresses have
to be configured
#show ppp ppp0 configuration
# show ppp [interface] link-status
#show ppp ppp0 link-status
Up / Down
OK
# show ppp [interface] ip-addr
#show ppp ppp0 ip-addr
local: 192.168.2.1
remote: 192.168.2.2
OK
Chapter 11 – Point-to-Point Protocol
134