Ricoh IM C300 Service Manual page 1590

Dedicated Transmission Parameters
1 0 0
1 0 0
1 0 1
1 0 1
1 1 0
1 1 0
1 1 1
1 1 1
4- Not used
7
Switch 03
No FUNCTION
0- Inch-mm conversion
1 before tx
Bit 1: 0, Bit 0: 0
= Inch-mm conversion
available
Bit 1: 0, Bit 0: 1 = Inch
only
Bit 1: 1, Bit 0: 0 = Not
used
Bit 1: 1, Bit 0: 1 =
Disabled
2- DIS/NSF detection
3 method
Bit 3: 0, Bit 2: 0
= First DIS or NSF
Bit 3: 0, Bit 2: 1
= Second DIS or NSF
Bit 3: 1, Bit 2: 0 = Not
used
Bit 3: 1, Bit 2: 1 =
Disabled
4 V.8 protocol
0: Off
1: Disabled
SM
0 19200
1 21600
0 24000
1 26400
0 28800
1 31200
0 33600
1 Disabled
Do not change the settings.
COMMENTS
If "inch only" is selected on the machine uses inch-based resolutions
for scanning, the printed copy may be slightly distorted at the other
end if that machine uses mm-based resolutions.
If the setting is "Inch-mm conversion available ", Inch-mm conversion
become effective to the special senders.
If the setting is "Disabled", the bit switch setting is used.
(0, 1): Use this setting if echoes on the line are interfering with the set-
up protocol at the start of transmission. The machine will then wait for
the second DIS or NSF before sending DCS or NSS.
If the setting is "Disabled", the bit switch setting is used.
If transmissions to a specific destination always end at a lower modem
rate (14,400 bps or lower), disable V.8 protocol so as not to use V.34
protocol.
115 D0CK