Ricoh IM C300 Service Manual page 1416

Printer Service Mode
1001
008 Bit Switch 8
bit 0 DFU
to 2
bit 3 BW Printing without the PJL Color Command
"DATAMODE"
This setting enables a job to be printed in BW without the PJL color command
"DATAMODE".
Note: Color jobs will not be printed without the PJL color command "DATAMODE".
Note:This is available for PCL, PS only.
bit 4 DFU
to 5
bit 6 Orientation Auto Detect Function (PS)
Automatically chooses page orientation of PostScript jobs (Landscape or Portrait)
based on the content.
PJL/PDL Color Command Priority
This setting enables the priority of a PDL color command to be changed when a
PJL color command is "@PJL RENDERMODE = GRAYSCALE" in a job.
Note:This is available for PCL,RPCS,PS.
bit 7 [PDF]: Orientation Auto Detect Function
Automatically chooses page orientations of PDF jobs (Landscape or Portrait)
based on the content.
1001
009 Bit Switch 9
bit PDL Auto Detection timeout of jobs submitted
0 via USB or Parallel Port (IEEE 1284).
To be used if PDL auto-detection fails. A failure of PDL autodetection does not
necessarily mean that the job can not be printed. This bit switch tells the device
whether to time-out immediately (default) upon failure or to wait 10 seconds.
bit DFU
1
bit Job Cancel after Jam
2 This setting enables it to be specifed whether jobs will be cancelled after a jam
occurs.
Note: If this BitSw is enabled, printing under the following conditions might result in
problems:
- Job submission via USB or Parallel Port
D0CA/D0C9/D0C8/D0CB
Bit Switch
Bit Switch
0
Disabled
(Immediately)
-
Not cancelled
3-424
0 1
- -
Disabled Enabled
- -
Enabled Disabled
PJL Priority PDL Priority
Enabled Disabled
1
Enabled
(10 seconds)
-
Cancelled
SM Appendices