Ricoh IM C300 Service Manual page 1540

Bit Switches – 2
4 400 x 400 Super
Fine
5 600 x 600 Reserve
6 Reserve
7 mm/inch
This setting selects mm/inch conversion for mail transmission.
0: Off (No conversion), 1: On (Conversion)
When on (set to "1"), the machine converts millimeters to inches for sending mail. There is no
switch for converting inches to millimeters.
Unlike G3 fax transmissions which can negotiate between sender and receiver to determine
the setting, mail cannot negotiate between terminals; the mm/inch selection is determined by
the sender fax.
When this switch is Off (0):
•
Images scanned in inches are sent in inches.
•
Images scanned in mm are sent in mm.
•
Images received in inches are transmitted in inches.
•
Images received in mm are transmitted in mm.
When this switch is On (1):
•
Images scanned in inches are sent in inches.
•
Images scanned in mm are converted to inches.
•
Images received in inches are transmitted in inches.
•
Images received in mm are converted to inches.
I-fax Switch 02 (SP No. 1-102-003)
No Function
0 RX Text Mail Header Processing
This setting determines whether the header information is printed with text e-mails when they
are received.
0: Prints only text mail.
1: Prints mail header information attached to text mail.
When a text mail is received with this switch On (1), the "From" address and "Subject" address
are printed as header information.
When a mail with only binary data is received (a TIFF-F file, for example), this setting is ignored
and no header is printed.
1 Output from Attached Document at E-mail TX Error
This setting determines whether only the first page or all pages of an e-mail attachment are
printed at the sending station when a transmission error occurs. This allows the customer to
see which documents have not reached their intended destinations if sent to the wrong e-mail
SM
Resolution is set for "Bit 2 200 x 400.
65
Comments
D0CK