Ricoh IM C300 Service Manual page 1556

Bit Switches – 3
Communication Switch 10 (SP No. 1-104-017)
No Function
0- Memory transmission: Maximum number of dialing attempts to the same
7 destination
Communication Switch 11 – Not used (do not change the settings.)
Communication Switch 12 (SP No. 1-104-019)
No Function
0- Memory transmission: Interval between dialing attempts to the same
7 destination
Communication Switch 13 – Not used (do not change the settings.)
Communication Switch 14 (SP No. 1-104-021)
No Function
0 Inch-to-mm conversion during
transmission
0: Disabled, 1: Enabled
1- Not used
5
6- Available unit of resolution in
7 which fax messages are
received
Bit 7 Bit 6
0 0
0 1
1 0
1 1
Communication Switch 15 – Not used (do not change the settings)
Communication Switch 16 – Not used (do not change the settings)
SM
Comments
0: In immediate transmission, data scanned in inch format are
transmitted without conversion.
In memory transmission, data stored in the SAF memory in
mm format are transmitted without conversion.
Note: When storing the scanned data into SAF memory, the
fax unit always converts the data into mm format.
1: The machine converts the scanned data or stored data in
the SAF memory to the format which was specified in the set-
up protocol (DIS/NSF) before transmission.
Do not change the factory settings.
For the best performance, do not change the factory settings.
The setting determined by these bits is informed to the
transmitting terminal in the pre-message protocol exchange (in
the DIS/NSF frames).
Unit
mm
inch
mm and inch
Not used
81
Comments
01 – FE (Hex)
times
Comments
01 – FF (Hex)
minutes
D0CK