Ricoh IM C300 Service Manual page 1531

System Switch 04 (SP No. 1-101-005)
No Function
0- Not used
2
3 Printing dedicated tx
parameters on Quick/Speed
Dial Lists
0: Disabled
1: Enabled
4- Not used
7
System Switch 05 - Not used (Do not change the factory settings.)
System Switch 06 - Not used (Do not change the factory settings.)
System Switch 07 - Not used (Do not change the factory settings.)
System Switch 08 - Not used (Do not change the factory settings.)
System Switch 09 (SP No. 1-101-010)
No Function
0 Addition of image data from
confidential transmissions on the
transmission result report
0: Disabled 1: Enabled
1 Print timing of communication
reports on the Journal when no
image data was exchanged.
0: After DCS/NSS communication
(default),
1: After polling
2 Automatic error report printout
0: Disabled 1: Enabled
3 Printing of the error code on the
error report
0: No 1: Yes
4 Not used
5 Power failure report
0: Disabled
D0CK
Comments
Do not change these settings.
1: Each Quick/Speed dial number on the list is printed with the
dedicated tx parameters (10 bytes each).
The first 10 bytes of data are the programmed dedicated tx
parameters; 34 bytes of data are printed (the other 24 bytes
have no use for service technicians).
Do not change these settings.
Comments
If this feature is enabled, the top half of the first page of
confidential messages will be printed on transmission
result reports.
0: The Journal is printed only when image data is sent.
1: The Journal is printed when any data is sent.
0: Error reports will not be printed.
1: Error reports will be printed automatically after failed
communications.
1: Error codes are printed on the error reports.
This can be used for detecting an error which occurs
rarely.
Do not change this setting.
1: A power failure report will be automatically printed after
the power is switched on if a fax message disappeared
56
Bit Switches – 1
SM