Ricoh IM C300 Service Manual page 1419

1001
out of paper, printing will occur from the Bypass Tray.
Disabled (=1):
Limitless Paper Feeding is not applied to the Bypass Tray.
If a tray other than the Bypass Tray matches the job's paper size and type but has run
out of paper, printing will stop and an alert will appear on the LCD screen, stating that
the tray has run out of paper. This prevents unexpected use of the Bypass Tray.
Limitations when this BitSw is set to "1":
- Jobs that contain more than one paper size cannot be printed.
- The "Paper Tray Priority: Printer" setting must be configured to a tray other than the
Bypass Tray.
bit DFU
3
bit "Apply Auto Paper Select" to
4 Override Paper Size or Paper Type of the
Device
If this BitSw is enabled, the "Apply Auto Paper Select" setting will decide if the paper
size or paper type that is specified in the device settings should be overridden by the
job's commands when "Tray Setting Priority" is set to "Driver/Command" or "Machine
Setting(s): Any Type".
- Apply Auto Paper Select = OFF: Overridden (priority is given to the job's
commands)
- Apply Auto Paper Select = ON: NOT overridden (priority is given to the device
settings)
bit Not Used
5
bit Tray Selection when a Paper Mismatch
6 Occurs.
This BitSw enables the inactive auto paper select tray to be unselectable when a
paper size/type mismatch occurs.
bit Not Used
7
1001
012 Bit Switch C
bit 0 DFU
to 2
bit 3 Switching paper discharge operation when the
limit number of sheets stapled is exceeded
SM Appendices
Bit Switch
-
Disabled
-
Disabled
Bit Switch
0
-
one by one
3-427
Printer Service Mode
-
Enabled
-
Enabled
1
-
Upper limit
number
D0CA/D0C9/D0C8/D0CB