Ricoh IM C300 Service Manual page 1555

Communication Switch 0B (SP No. 1-104-012)
No Function
0- Not used
2
3 Conditions required for
Transfer Result Report
transmission
4 Printout of the message
when acting as a Transfer
Station
0: Disabled, 1: Enabled
5- Not used
7
Communication Switch 0C - Not used (do not change the settings)
Communication Switch 0D (SP No. 1-104-014)
No Function
0- The available memory threshold,
7 below which ringing detection (and
therefore reception into memory) is
disabled
Communication Switch 0E (SP No. 1-104-015)
No Function
0- Minimum interval between
7 automatic dialing attempts
Communication Switch 0F – Not used (do not change the settings.)
D0CK
Comments
Do not change these settings.
0: Always transmitted
1: Only transmitted if there was an error
When the machine is acting as a Transfer Station, this bit
determines whether the machine prints the fax message
coming in from the Requesting Terminal.
Do not change the settings.
Comments
00 to FF (Hex), unit = 4 kbytes
(e.g., 06(H) = 24 kbytes)
One page is about 24 kbytes.
The machine refers to this setting before each fax
reception. If the amount of remaining memory is below
this threshold, the machine cannot receive any fax
messages.
If this setting is kept at 0, the machine will detect ringing
signals and go into receive mode even if there is no
memory available. This will result in communication
failure.
Comments
06 to FF (Hex), unit = 2 s
(e.g., 06(H) = 12 s)
This value is the minimum time that the machine waits
before it dials the next destination.
80
Bit Switches – 3
SM