Installing The V100; Free-Standing; Rack-Mounting; Installing Generic Modules - H3C SecPath V100-E Installation Manual

Installing the V100-E
You can place the V100-E on a workbench or mount it in a 19-inch standard rack.

Free-Standing

Place the V100-E on a clean and flat workbench. To prevent any damage, observe the following:
Ensure the workbench is stable enough.
Allow 10 cm (3.9 in.) of clearance around the ventilation openings.
Do not place heavy stuff on the V100-E.

Rack-Mounting

The V100-E is designed to be mounted in 19-inch standard racks. Table 3-1 shows its physical
dimensions.
Table 3-1 Physical dimensions of the V100-E
H3C SecPath V100-E security gateway
Follow these steps to rack-mount the V100-E:
Step1 Check the grounding and stability of the rack. Use the screws to fix the mounting brackets at both sides
near the front panel of the device.
Step2 Put the device in a rack tray. Depending on the actual situation, slide the device along the guide rails to
an appropriate place.
Step3 Fix the mounting brackets to the rack posts with suitable antirust pan-head screws. Make sure that the
device is placed horizontally and securely fixed.
Figure 3-2 Install the V100-E in a rack
(1)
(1) Screws (four)
(3) Guide rail

Installing Generic Modules

For how to install MIMs, refer to MIM Modules.
Model Physical dimensions (H × W × D)
44 × 436 × 430 mm (1.73 × 17.17 × 16.93 in.)
(excluding rubber feet)
(2)
(2) Mounting bracket
3-2
(3)