Chapter 8 Multifunctional Interface Modules; Multifunctional Interface Module Options; Installing And Removing An Mim - H3C SecPath V1000-A Installation Manual

Installation Manual
H3C SecPath V1000-A Security Gateway

Chapter 8 Multifunctional Interface Modules

8.1 Multifunctional Interface Module Options

Following are the Multifunctional Interface Modules (MIMs) available for the security
gateway:
I. Ethernet interface modules
1-port 10Base-T/100Base-TX Fast Ethernet interface module (1FE)
2-port 10Base-T/100Base-TX Fast Ethernet interface module (2FE)
1-port 10Base-T/100Base-T/1000Base-TX Ethernet interface module (1GBE)
2-port 10Base-T/100Base-T/1000Base-TX Ethernet interface module (2GBE)

8.2 Installing and Removing an MIM

Caution:
The electromagnetic shielding (EMS) gaskets on the front panel of an MIM have
special EMS effect for the entire security gateway. So keep the gaskets intact when
removing or replacing an MIM and do not damage them.
Before installing MIMs, read "Chapter 2 Preparation for Installation" carefully.
I. Tools
ESD-preventive wrist strap
II. Installing an MIM
Caution:
Before performing any of the following operations, make sure you have completely
powered down the security gateway to avoid getting electric shocks.
Step 1: Place the security gateway with its front facing towards you.
Step 2: Turn off the mains supply and remove the power cord.
Chapter 8 Multifunctional Interface Modules
8-1