Checking Power Steering Fluid - Mercury Racing 500R Operation And Maintenance Manual

4. Remove the power trim fill cap. The fill cap only requires 1/4 turn to
remove.
a
5. The fluid level should be approximately 25 mm (1 in.) from the top of the
fill neck. Add Quicksilver or Mercury Precision Lubricants Power Trim and
Steering Fluid. If not available, use automotive automatic transmission
fluid (ATF).
Description
Power Trim and
Steering Fluid
6. Install the power trim fill cap. Tighten fill cap 1/4 turn. Cap will snap in
place. Do not tighten beyond this point.

Checking Power Steering Fluid

Dirt or contaminants in the hydraulic steering system can damage the
steering system's internal components. Damaged components can lead to
serious injury or death due to loss of boat control. Do not allow dirt or
contamination to enter the helm, lines, or cylinder of this steering system
and perform all hydraulic inspections, service, or assembly procedures in a
clean work area.
MAINTENANCE
b
a -
b -
c -
d -
c
d
29312
Where Used
Power trim system
WARNING
!
116
Tilt support lever
Power trim fill cap
Tilt support bracket
Pedestal
Part No.
92-858074K01
eng