Table of Contents
Advertisement
3. To prevent a loss of the outboard, secure the outboard to the transom
with the two transom bracket clamp screws and two mounting bolts. Drill
two 7.9 mm (5/16 in.) holes through the transom bracket mounting holes.
Fasten with two bolts, flat washers, and locknuts. Use a marine
waterproofing sealer in the holes and around the bolts to make the
installation water tight. Tighten the bolts to the specified torque.
a
Description
Transom bracket mounting bolts
Steering Cable Installation
1. Lubricate the entire cable end with Mercury or Quicksilver 2‑4‑C with
PTFE.
Tube Ref
No.
95
eng
ENGINE INSTALLATION
a
b
c
Description
2-4-C with PTFE
b
Power tilt models
Manual tilt models
a -
Bolt (2)
b -
Washer (2)
d
c -
Locknut (2)
d -
Transom bracket clamp screw
(2)
28971
Nm
13.5
Where Used
Steering cable end
113
d
c
32041
lb‑in.
28722
Part No.
92-802859A 1
lb‑ft
10
Advertisement
Table of Contents
