Table of Contents
Advertisement
2. Commissioning
Before the first start of operation you have to install the provided Seunis
software. Please follow the installation instructions given by the software.
Before starting the software connect the device and turn it on. The software
automatically detects the connected instrument.
Remark: In rare cases, the device cannot be found. Please see the troubleshooting
section
14
for further information.
2.1 General Remarks
The Seunis measurement software was designed to make series measure-
ments and therefore the central element of the main window is a spread-
sheet-like table. For a better understanding, some regularly used terms are
defined below:
Sample
Sample List
(D)TTC =
(Differential)
Three-Term
Correction
12TC =
Twelve Term
Correction
Measurement
Modes
Synonym for object / device under test (DUT)
Collection of samples in the spreadsheet table
Error correction method, removes systematic device &
external cable/connector errors
Error correction method for full 2-port S-parameter
measurements. Only used if full 2-port measurement
mode is available
The software is capable of measuring various
parameters (impedance, S11, etc.). These
functionalities are called measurement modes
T3SP-Series Operator's Manual
9
931776 RevE
Advertisement
Table of Contents
