Teledyne T3SP Series Operator's Manual page 20

T3SP-Series Operator's Manual
mouse wheel. Alternatively the buttons in the toolbar can be used.
Zooming only in a certain direction can be achieved by using the mouse-
wheel while holding the CTRL-key (x-axis) or the SHIFT-key (y-axis). A "fit-to-
screen" can be achieved by double right-clicking within the diagram.
Pressing the button with the lock symbol has the effect that in time domain
measurement modes (as TDR & DTDR) the zoom is locked to the current
zoom of the Oscilloscope Window. The result traces can be positioned by
holding the middle button down while moving the mouse.
Measurement Button
A small green arrow button is located in the status bar to start a measure-
ment. Pressing the button has the same effect as pressing the measurement
button in the Main Window or pressing F5.
Cursors
The software features (delta) cursors for each displayed sample in the Re-
sult Visualization Window. Cursors can be set by pressing down the CTRL
key while left-clicking a trace. The cursor values are displayed on top of the
diagram in the cursor value field. If two cursors are set up for a trace the
delta value is displayed as well. The cursor value field can be double-clicked
to open an overview tabular.
Pressing the CTRL key and clicking a cursor again deletes the cursor. Alter-
natively all cursors can be cleared by pressing the CLR button in the toolbar.
Cursor labels can be set/reset by right-clicking them.
Horizontal cursors can be moved to the desired position by holding down
the left mouse button.
20
931776 RevE