Teledyne T3SP Series Operator's Manual page 25

•
If Load Project on Startup is checked, the last known project file is
automatically reloaded on startup.
•
If Restore Windows Position is checked, the last known window ar-
rangement is restored on startup.
•
The software automatically saves backups to the user's application
folder, and the backup interval can be set (minutes). If set to "0", im-
mediate backup is activated, if set to "-1", backup is completely turned
off (this is NOT recommended).
Device tab:
•
In most cases the software is started with a connected device and it is
intended to connect automatically. However if the software shall be
started with a Viewer Key it is possible to deactivate the Auto-Connect
on Startup.
•
Data Rate: data transfer rate between device and software (read only)
•
The Single Shot Measurement box should be checked, if all average
measurements shall be carried out at once. Otherwise all measure-
ments can be performed separately. This may be desirable in some
very specific applications. By default this option is turned on.
•
In some rare cases it may be necessary to switch off the instable signal
protection during measurements, for this purpose the Ignore Instable
Signal box can be checked. Usually this option should be unchecked.
•
The last valid TTC is loaded automatically if the box is checked.
•
In the ESD auto-protection field, the number of seconds is set after
which the devices ESD-protection is activated automatically.
T3SP-Series Operator's Manual
25
931776 RevE