Teledyne T3SP Series Operator's Manual page 66

signature field is printed to the PDF. This can be replaced by an "auto-
matic generated" statement (Seunis.config: Suppress signature
in pdf = "true" ).
Summary table:
ments.
Diagrams:
measurements and additional details in side tables.
Group statistics:
software groups the measurements respectively and shows additional
information for these groups (mean/min./max. impedance and stan-
dard deviation, pass/fail).
Please note: some specific information for the PDF export can be switched
on/off in the Advanced tab in the Options Dialog (see section 2.5.4).
2. S /DS Measurements: The (differential) reflection coefficient DS
11 11
and S are exported to two diagrams: the magnitude (in dB) and
11
phase vs. frequency. Additionally an overview table is created.
3. Full 2-Port Measurements: The magnitude (in dB) vs. frequency of all
S-parameters are exported to four diagrams. Additionally an overview
table is created.
Further information as system state, user & device IDs, and freely definable
Project Comment
Please note: measurements of different kinds (e.g. TDR/S11) cannot be combined
into a single PDF file. In this case the measurement mode of the first selected sample
1 Project Comment can be set via the main menu entries Edit
2 The default Test Standard can be set in the config file Seunis.config
List showing the results for the individual measure-
Impedance traces (incl. tolerance masks) for individual
The user can specify criterions (dialog appears). The
1
and Test Standard
T3SP-Series Operator's Manual
2
IDs are printed to the PDF reports.
Project Comment
931776 RevE
11
66