Mechanical Installation - Jetter JM-206-230 User Manual

2 JetMove 206B-230 - Installation Instructions
2.2
24

Mechanical Installation

Prior to installing the digital servo amplifier, check it for possible
transport damages.
Check the shipment for completeness.
Fix the cable strap serving as strain relief and motor cable shield next
to connector X62 (see fig. 3, page 22).
To ensure proper functioning of the JetMove 206B-230, check whether
the mounting plate in the electric cabinet is unpainted.
The only possible mounting position is vertical - see siehe fig. 4,
page 25.
For sufficient air flow there has to be a clearance of 100 mm above and
below the device.
Mark on the panel two positions for the fastening screw threads of the
JetMove 230B-230 (see fig. 4, page 25).
Drill the holes and cut the respective threads into the panel.
Screw the corresponding fitting bolts into the thread by approximately
half of their length.
By means of the oblong holes in the rear plate, hang up the JetMove
206B-230 by the fitting bolts; then screw them tightly.
Jetter AG