Reset User Data - ABB OmniCore Operating Manual

10 Install, update, restart, and other configuration

10.6 Reset user data

10.6 Reset user data
Overview
We recommend to perform a reset user data:
Procedure
Use the following procedure to reset the system settings:
254
• when you want to reset the RAPID in the system.
• when you want to restore the system to its original state by resetting RAPID
and system parameters.
• when you want to remove the user configured safety settings and load the
default safety settings.
1 On the start screen, tap Settings, and then Backup & Recovery.
2 On the left sidebar tap Reset user data.
The Reset user data page is displayed.
3 Select one of the following reset data options:
• Reset RAPID: To reset the RAPID data of the loaded system.
• Reset RAPID and System Parameters: To restore the system to its
original state by resetting the RAPID and system parameters.
Note
If this option is selected, the content in the TEMP folder will be
emptied when the controller is restarted.
• Reset safety setting: To remove the user configured safety settings
and load the default safety settings.
4 Tap Reset.
A confirmation message is displayed.
5 Tap OK.
The controller is restarted and the system is updated according to the selected
reset data settings.
© Copyright 2019-2021 ABB. All rights reserved.
Operating manual - OmniCore
3HAC065036-001 Revision: J