Restart - ABB OmniCore Operating Manual

10.3 Restart

Restart controller
ABB robot systems are designed to operate unattended for long times. There is
no need to periodically restart the functioning systems.
Restart the controller when:
Use the following procedure to restart the controller:
Using the QuickSet menu:
Using the Settings application:
Procedure
There are certain cases under which only the FlexPendant needs to be restarted.
For example, restart the FlexPendant while troubleshooting.
Use the following procedure to restart only the FlexPendant:
Operating manual - OmniCore
3HAC065036-001 Revision: J
10 Install, update, restart, and other configuration
• new hardware has been installed.
• the robot system configuration files have been changed.
• a new system has been added and is to be used.
• a system failure (SYSFAIL) has occurred.
Note
When the controller is restarted the FlexPendant is also restarted.
1 Tap on the QuickSet button and select the Logout/Restart tab.
The Logout/Restart page is displayed.
2 In the Controller section tap Restart.
The Restart window is displayed.
3 Tap OK.
The controller is restarted.
1 On the start screen, tap Settings.
The Settings page is displayed.
2 At the bottom of the Settings page tap Restart.
The Restart window is displayed.
3 Tap OK.
The controller is restarted.
Note
If the FlexPendant freezes during operation, press the reset button to restart the
FlexPendant. For more details, see
1 Tap on the QuickSet button and select the Logout/Restart tab.
The Logout/Restart page is displayed.
2 In the FlexPendant section tap Restart FlexPendant.
© Copyright 2019-2021 ABB. All rights reserved.
Reset button on page 18.
Continues on next page
10.3 Restart
249