Configuring The Default View During System Events - ABB OmniCore Operating Manual

2 Navigating and handling the FlexPendant

2.3.6 Configuring the default view during system events

2.3.6 Configuring the default view during system events
Overview
This feature is used to configure a particular app view during start up or when
switching to different operating modes.
Procedure
Use the following procedure to configure the default view of FlexPendant for system
events:
48
Note
This configuration is disabled when the operating mode is Auto.
1 On the start screen, tap Settings.
2 Tap FlexPendant.
The Launch on System Event page is displayed.
3 For a system event, tap the list and select a desired view.
Following system events are available :
• Switching to Auto: Select this option to define the FlexPendant view
when switching to auto mode.
• Switching to Manual: Select this option to define the FlexPendant view
when switching to manual mode.
• Switching to Manual Full Speed: Select this option to define the
FlexPendant view when switching to manual full speed mode.
• FlexPendant Startup: Select this option to define the view when the
FlexPendant starts.
Note
Tap Clear to remove the current selected view.
4 Tap Save.
The changes are saved.
© Copyright 2019-2021 ABB. All rights reserved.
Operating manual - OmniCore
3HAC065036-001 Revision: J