Simulating The Signals And Changing The Signal Values - ABB OmniCore Operating Manual

8 Handling inputs and outputs, I/O

8.4 Simulating the signals and changing the signal values

8.4 Simulating the signals and changing the signal values
Simulating the signals
A signal can be simulated.
xx2100001551
Use the following procedure to simulate a signal:
Continues on next page
238
Note
You cannot simulate a signal if its access level is set to Read Only.
1 On the start screen, tap I/O, and then select Signals from the menu.
2 Use the Filter list or use the search box to navigate to a particular signal.
3 Tap on the Simulate button available for the signal.
The signal is changed to a simulated signal.
Note
Once a signal is simulated the Remove Simulation button is displayed for
the signal.
Note
If there is a cross connection created between two signals, changing the value
of one signal automatically changes the value of the corresponding cross
connected signal.
© Copyright 2019-2021 ABB. All rights reserved.
Operating manual - OmniCore
3HAC065036-001 Revision: J