Adjusting The Backlight And Contrast Of The Controller Display; Resetting The Operating Language; Defining The Metering And Control Process - ProMinent DULCOMETER Assembly And Operating Instructions Manual

ð The controller now changes
into the continuous display.
From the continuous display
you can access all controller
functionalities via the
Adjusting the backlight and
7.2
contrast of the controller dis‐
play
Continuous display ➨
[Setup] ➨ [Device setup] ➨
[Device configuration] ➨
Under this menu item you can set the
brightness and contrast of your controller
display to match the ambient conditions at
your installation location.
Resetting the operating lan‐
7.3
guage
Resetting the operating lan‐
guage
In the event that a foreign and hence
incomprehensible operating language
has been set, the controller can be
reset to the basic setting [English].
This is implemented by the simulta‐
neous pressing of the
If you no longer know whereabouts
you are in the operator menu, you
must press the
necessary until the continuous display
becomes visible again.
key.
➨ or
or
[Backlight]
and keys.
key as often as
Defining the metering and
7.4
control process
After you have integrated your controller
in the control path, you must make the
controller settings. Through the settings,
your controller is matched to your
process, so that it is rendered possible for
the controller to effectively control the
process.
To set up a controller, determine the fol‐
lowing parameters:
What type of a process is under con‐
n
sideration?
Should the controller operate as a
n
one-way or two-way control?
Which control variables exist?
n
Which control parameters are neces‐
n
sary?
What should the controller do in
n
[HOLD] ?
How should the actuators by con‐
n
trolled?
How should the outputs be set?
n
Commissioning
49