Fatal Error Responses - Microcom LDS2 Programming Manual

Chapter 5
Byte Mode
Responses Text and Verbose Mode Responses
(ASCII Hex)
0xD1 >NONEXISTENT COMMAND<
0xD3 >ZIP FILE ERROR<
0xD4 >FILE CONVERSION ERROR<
0xD5 >UNSUPPORTED FILE TYPE<
0xD6 >FILE NOT FOUND<
0xD7 >INADEQUATE ACCESS MODE<
0xDA >INADEQUATE FLASH SPACE<
0xF2 >FILE TOO LARGE<
0xFF >POWERED DOWN<
5.2.1

Fatal Error Responses

Fatal error responses are enquiry responses that halt the printer's current operation and
cause the indicator light or LED to flash RED in color. A fatal error condition persists until
removal of the condition causing the error and clearing the error. The printer provides
different methods of clearing the error including pressing the print button or display or if the
Autoload (D723,n,n) is enabled, new media detected by the printers internal registration
sensors will cause the printer to clear the error and load the new media.
These enquiry responses are sent from the printer to the host, when the appropriate
condition occurs, by issuing the "Ctrl+E" (^E) combination or by issuing the queued
"^D327)1" command. The printer may be configured to automatically reports errors and
status messages by using the ^D72x series commands. The following sections provide
further explanations of the various fatal error responses. Refer to the ^D550) command
regarding the types of enquiry response sets.
NOTE: The following section titles are the responses that the printer will generate once the
associating condition occurs and the printer processes an enquiry command. The first
response (between and including the ">" and "<" characters) is generated if text and
verbose responses have been enabled using the ^D550) command. The ASCII hex value
listed between the parenthesis characters, indicate the enquiry response if byte mode has
been enabled.
LDS2 Programming Manual - 880019-0202
Table 23 Enquiry Responses
Diagnostics and Troubleshooting
Definition
The received command does
not exist.
The received Zipped file has
an error.
The file was not converted
properly.
The received file is not
recognized.
The requested file does not
exist or cannot be found.
Incorrect password to a
higher access level.
Cannot save an item to the
flash memory due to lack of
space.
The sent graphic exceeds the
available memory.
The printer's power has been
removed.
5-7