D930)Level (Get Access Code Key); D931)Level, Password (Change Access Level); (List Access Passwords); D945)N (List Diagnostic Dump) - Microcom LDS2 Programming Manual

Chapter 2
2.7.2 ^D930)level
This command returns an access code that is used to change the printer's current access
level. Once issued, the access code is the same until the "^D930)" command is issued
again. Once an access code has been acquired, Microcom Corporation support is
contacted and a password will then be issued. This is only required when higher than
"BASIC" access level is desired. The "level" parameter is the desired access level (BASIC,
FACT, and SERVICE) and will only work for that access level. Refer to the "^D931)"
command for additional information regarding the access levels and their meanings.
2.7.3 ^D931)level, password
The "^D931)" command is used to change the access level of the printer. A password in
required to access a higher privilege level. The access levels may be changed to a lower
level without a password but would still require a password to set back to the original higher
level. The level parameter is the desired access level while the password parameter is the
actual password for that access level. The password is received by Microcom Corporation
support departments with the appropriate "^D930)" access code. The access levels and
their meaning are listed in the table below.
Access Level
FACT
SERVICE
BASIC
2.7.4 ^D932)
This command causes the printer to list the current access password along with the other
lower level passwords.
Example: If the current access level was SERVICE and the "^D932)" command was issued,
the SERVICE and BASIC access level passwords would both be reported.
2.7.5 ^D945)n
This command causes the printer to list all of the printer's current setup through the active
port and is used for setup and diagnostic purposes. Each line of the listing is terminated
with a CR LF (0x0D 0x0A) that may be used to assist in programming delineation while the
entire listing is terminated with either an additional CR+LF or 0x1A character depending on
the "^D550)" command configuration. The list is generated by issuing the command without
the "n" parameter. Issuing the "^D945)" command with the "?" character will always report
the "^D550)" commands configuration as "9" for VERBOSE mode because the "?" cause the
printer to report the VERBOSE descriptive text. The "n" parameter may be used to select
2-32
(Get Access Code Key)
Access Level Description
Access level intended for internal Microcom Corporation factory
personnel used to setup and configure the printer.
Access level intended for approved third party service groups used
to perform diagnostics, troubleshooting, and maintenance
Access level used by most users that provides access to most
commands with the exception of some diagnostics, troubleshooting
and maintenance capabilities.
Table 10

(List Access Passwords)

(List Diagnostic Dump)
Printer Commands
(Change Access Level)
capabilities.
Access Levels
LDS2 Programming Manual - 880019-0202