D392)1 (Restore Property Defaults); 2.4 5Xx Series Commands; D501)N (Select Emulation Mode); D506)N (Select Cutter Type) - Microcom LDS2 Programming Manual

Printer Commands
Serial Port parameters ("^D670)"), before executing any other command regardless of the
placement within the script file. This command should be sent to the printer outside a script
file as a part of a Flash memory update. Failure to issue the "^D391)1" command after a
Flash code update may cause the printer to become unstable.
2.3.22 ^D392)1
This command used to restore the printer's property command defaults to a known state.
This command may be sent from inside or outside a script. If this command is sent inside a
script file, the printer will transiently restore factory defaults. This command should be sent
to the printer outside a script file as a part of a Flash memory update. Failure to issue the
"^D392)1" command after a Flash code update may cause the printer to become unstable.
A reset (^D390) and/or power cycle is required for this command to complete.

2.4 5xx Series Commands

The 5xx series commands control the printer's configurable selections and may be issued
from outside and/or inside a script file. Commands will return the current status and/or
setting if the ^Dxx command is entered without an argument. Entering a question mark ("?")
after the ^Dxx command causes the printer to report the commands current setting as well
as the verbose description and help text associated with that particular command.
2.4.1 ^D501)n
Command used to select the printers emulation or language mode. Once set to a new
mode, only commands that are valid for that mode are accepted. This command requires
special access level control and it either set at the factory or by the printer display.
1 LDS1 Image Mode
2 LDS2
3 FGL
2.4.2 ^D506)n
This command used to select the type of cutter installed on the printer. The valid parameters
for "n" listed below. The printer requires a reset and/or a power cycle must occur after
setting this command. To adjust the dispense distance for the available cutters, refer to the
"^D642)" command.
0 None
1 Guillotine Cutter
2 Rotary Cutter
3 Microcom Rotary Cutter
LDS2 Programming Manual - 880019-0202
(Restore Property Defaults)
(Select Emulation Mode)
(Select Cutter Type)
Chapter 2
2-11