Microcom LDS2 Programming Manual page 110

Table of Contents

Advertisement

^D
VALUE
COMMAND
637
n
Set X Offset: Sets the offset in the X direction and is the same as the
OFX header parameter. The value is persistent and non-volatile if sent
outside of a script file. The value for "n: is the distance that the field will
move to the right in the X direction of the format and entered using the
units selected by the D564 command.
638
n
Set Y Offset: Sets the offset in the Y direction and is the same as the
OFY header parameter. The value is persistent and non-volatile if sent
outside of a script file. The value for "n: is the distance that the field will
move to the right in the Y direction of the format and entered using the
units selected by the D564 command.
640
n
Set Delay Time Between Formats: Command used to add a delay
between prints. The value for "n"entered in seconds and has a maximum
value of 15.
641
n
Set Retraction Delay Time: Command used with the D597 dispense
modes and controls how long the printer will wait before retracting the
media after dispensing. The value for "n" entered in seconds and has a
maximum value of 15.
642
n
Set Advance/Retraction Distance: Sets the distance that the printer
used for advancing the media after printing and then retracts the same
distance. Used in conjunction with the D597 dispense modes.
644
n
Set Idle Recognition Delay: Used in conjunction with the ^D597)3
command and sets the time that the printer goes idle before advancing.
The value for "n" entered in as decimal seconds with tenths of a second
resolution.
645
n1,n2
Set Advance/Retract Speed: Sets the advance/retract speed of the
printer when using the D597 dispense modes. The value for "n1" sets
the advance speed while the value for "n2" sets the retraction speed.
646
dc,dp
Set Printhead Parameters: Used to set the printhead parameters of the
printer. The "dc" sets the dot count while the "dp" sets the dot bytes per
row. Only trained service providers should use this command to prevent
damaging the printer by not following proper procedures.
648
n
Set Reflective to Printhead Distance: The distance from the reflective
blackline sensor to the printhead distance. This command is set at the
factory to reflect the model used.
649
n
Set Transmissive to Printhead Distance: The distance from the
transmissive sensor to the printhead distance. This command is set at
the factory to reflect the model used.
650
n
Set AGD Distance: This is a format header parameter and sets the
distance that the printer will not trigger. This is useful when looking to
skip areas on the media that might false trigger a registration mark.
LDS2 Programming Manual - 880019-0202
6-11

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LDS2 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

880019-0202

Table of Contents