Microcom LDS2 Programming Manual page 107

^D VALUE COMMAND
508 n Select LPD Type: Selects the type of LPD (Label Present Detector)
installed on the printer; n = 0 none, 1 reflective, 2 transmissive.
509 n Select INPUT 1 Response: Selects when the optional input 1 sensor
would report the >INPUT 1< message. n = 0 no response, 1 >INPUT 1<
message when sensor blocked, 2 >INPUT 1< message when sensor
unblocked, 3 error when blocked, 4 error when unblocked.
511 n Select INPUT 2 Response: Selects when the optional input 2 sensor
would report the >INPUT 2< message. n = 0 no response, 1 >INPUT 2<
message when sensor blocked, 2 >INPUT 2< message when sensor
unblocked, 3 error when blocked, 4 error when unblocked.
541 n Select Button 1 Response: This command is used to select the
operation and response of Button 1 which is typically referred to as the
print button.
1
2
3
4
5
550 n Select Response Set: This command used to select the response set.
The response sets determine how the printer will react to commands,
functions, and enquiry responses.
1
2
9
564 n Select Linear Measurement Units: This command is used to select the
prevailing unit of measure the printer will use.
1
2
565 n Select Speed Units: This command is used to select the desired unit of
measure used for the speed parameter. This command is independent
from the "^D564)" command.
1
2
566 n Select Temperature Units: This command is used to select the desired
unit of measure used for the temperature parameter.
1
2
6-8
Short press = reprint; button held = continuous feed (default)
Short press = form feed; button held = continuous feed
Short press = ">BUTTON 1 TAPPED<" response;
button held = continuous feed
Short press = ">BUTTON 1 TAPPED<";
button held = ">BUTTON 1 HELD<"
Short press = Initiates a TOF (^D311); button held = continuous
feed
Text (Default)
Byte
Verbose
Inches
Millimeters
Inches per Second (ips)
Centimeters per Second (cm/sec)
Fahrenheit
Centigrade
LDS2 Programming Manual - 880019-0202