Microcom LDS2 Programming Manual page 105

The following is the list of ^D commands in numeric order (Commands follow the "^Dxxx)"
formatting unless otherwise noted):
^D VALUE COMMAND
200 Script Header: Followed by fields that control the placement and type
of fields to be printed. Header parameters in order: lsx, lsy, gap, dtm,
spd, det, ofx, ofy, agd
202 n Text Replacement Header: Command used to recall a saved format (n)
and replace the text data in the script.
203 Direct Image Script Header: This command replaces the need of the
D200 script header and allows users to print a graphic without needing to
save it to the printer first. The ^F and ^T fields are ignored when printing a
full-page graphic image. Header parameters in order:
lsx,lsy,gap,dtm,spd,det,ofx,ofy,agd,binary tag, file size.
300 n Print Command: Prints a single label or starts the printing of a batch of
labels that matches the value for "n" (Equivalent to ^C).
305 n Infinity Print: If "n" is set to a 1, the printer will print the script until the
printer is turned off.
311 1 Issue TOF: The printer will issue a TOF (Top of Form) using the
configured sensor set by the ^D508) command.
312 1 Form Feed: This command cause a blank form based on the last script
header to be printed (Equivalent to the ^L).
313 n1,n2 Advance distance and Speed: The value for n1 sets the advance
distance while the value for n2 sets the advance speed.
323 1 List Enablements: Command reports the printers enablement commands
to the printers active port (Equivalent to the ^Y).
324 1 List Statistics: Command reports the printers statistical information
to the printers active port (Equivalent to the ^W).
325 1 List Selections: Command reports the printers selection commands
to the printers active port(Equivalent to the ^U).
326 1 List Settings: Command reports the printers setting commands
to the printers active port (Equivalent to the ^V).
327 1 List Status: Command reports the printers current status to the printers
active port (Equivalent to the ^E).
339 size Load Firmware: Command used to update the printers firmware. The
"size" parameter is the size of the download zip file.
6-6 LDS2 Programming Manual - 880019-0202