Fatal Error Responses; Table 6 Enquiry Responses - Microcom 226 User Manual

Printer Modes
Byte Mode
Responses Text and Verbose Mode Responses
(ASCII Hex)
0xD7
0xD9
0xDA
0xDB
0xDC
0xE1
0xE2
0xE3
0xE4
0xF0
0xF1
0xF2
0xFF
4.2.2

Fatal Error Responses

Fatal error responses are enquiry responses that halt the printer's current operation and
cause the indicator light or LED to flash RED in color. A fatal error condition persists until
the condition causing the error is removed and the error is cleared. These enquiry
responses are sent from the printer to the host, when the appropriate condition occurs, by
issuing the "Ctrl+E" (^E) combination or by issuing the queued "^D327)1" command. The
printer may be configured to automatically reports errors and status messages by using the
^D72x series commands. The following sections provide further explanations of the various
fatal error responses. Refer to the ^D550) command regarding the types of enquiry
response sets.
16
>INADEQUATE ACCESS MODE<
>FILE IS READ ONLY<
>INADEQUATE FLASH SPACE<
>I/O FAILURE<
>FONT/GRAPHIC NOT FOUND<
>SWITCH 0 ACTUATED<
>SWITCH 1 ACTUATED<
>SWITCH 2 ACTUATED>
>TOF SWITCH ACTUATED<
>FIELD OFF IMAGE<
>COMPOSITION ERROR<
>GRAPHIC TOO LARGE<
>POWERED DOWN<
Table 6
Incorrect password to a higher
File is read only and cannot be
Cannot save an item to the flash
memory due to lack of space.
The Input/Output circuitry has
The requested file does not exist
Switch 0 has been actuated.
Switch 1 has been actuated.
Switch 2 has been actuated.
coordinates exceed the print
A script cannot be printed onto a
The sent graphic exceeds the
The printer's power has been
Enquiry Responses
226/426 User's Guide
Chapter 4
Definition
access level.
deleted.
failed.
or cannot be found.
The TOF switch has been
actuated.
An image placement
head or form size.
label due to incorrect size.
available memory.
removed.