D637)N (Offset X Direction); D638)N (Offset Y Direction); D639)N (Set Centering Offset); D640)N (Set Delay Time Between Labels) - Microcom LDS2 Programming Manual

Chapter 2
Emitter
(Not Used)
Detector
(Not used)
Figure 8
2.5.9 ^D637)n
This command moves or offsets all fields in the "X" direction without altering the field's
insertion points. The value is entered using the current selected unit of measure. This
command is also a parameter in the "^D200)" script header command. See also, OFX.
2.5.10 ^D638)n
This command moves or offsets all fields in the "Y" direction without altering the field's
insertion points. The value is entered using the current selected unit of measure. This
command is also a parameter in the "^D200)" script header command. See also, OFY.
2.5.11 ^D639)n
The "^D639)" command is used to set the image position offset in the X direction
independently of OFX or "^D637)" command. This command is used to compensate for
mechanical misalignments that can not be adjusted mechanically. The value is entered
using the current selected unit of measure or "^D564)" command. This command is a
"property" which means that it controls a specific distance that is set at the factory. The
property commands may be set back to their default values using the "^D392)1" command.
2.5.12 ^D640)n
This command delays the printing between labels in a batch. The value for "n" is entered in
decimal seconds and has a maximum of 15 seconds.
2.5.13 ^D641)n
This command is used in conjunction with the dispense modes ("^D597)" command) and/or
when a cutter is used. The delay controls how long the media is presented before being
retracted. The value for "n" is entered in decimal seconds with a 15 second maximum.
2.5.14 ^D642)n
This command is used to set the distance the media advances and retracts after printing
while in dispense modes ("^D597)" command) or when a cutter is installed. The distance
"n" is entered in based on the unit of measure selected by the "^D564)" command.
2-20
Upper Sensor
Lower Sensor
Detection Mode - Die-cut and Blowhole
(Offset X Direction)
(Offset Y Direction)
(Set Centering Offset)
(Set Delay Time Between Labels)
(Set Retraction Delay Time)
(Set Advance/Retract Distance)
LDS2 Programming Manual - 880019-0202
Printer Commands
Detector
Label
Stock
Emitter