Microcom LDS2 Programming Manual page 111

^D VALUE COMMAND
655 n Set Labels Printed Countdown: Command use to set a countdown of
printed labels. The value "n" sets the countdown and once reaching
zero, the >PM< status message is active. If "n" is set to a -1 value, the
field become a counter that increases with each print.
670 b,p,d,s Set Serial Port: Command sets the serial parameters of the printer. The
parameters are b=baud, p=parity,d=data, and s=stop.
673 n Set DHCP: A 1 enables the use of DHCP while a 0 disables it.
674 n Set Ethernet Port Number: Sets the port number for the Ethernet port.
Default is set to 9100.
675 n Set Printer IP Address: Sets the printer's IP address of the printer. The
printer default is set to DHCP and if an IP address is not assigned within
30 seconds, an Auto IP address will be assigned. DHCP may be
disabled and a static IP entered as well.
677 n Set the Gateway Address: Command sets the printer's Gateway
address. \Default is set to 0.0.0.0
679 n Set Net Mask Address: Command sets the printer's Net Mask address.
The default is set to 255.255.0.0.
680 n Set Gap Threshold: Sets the threshold or trip point that the printer uses
to determine a registration mark using the transmissive sensors. The
default for "n" is set to 30 and should work for most media types.
681 n Set Blackline Threshold: Sets the threshold or trip point that the printer
uses to determine a blackline registration mark using the reflective
sensor. The default value for "n" is set to 150 and should work for most
applications.
682 n Set Stock Out Threshold: Sets the threshold or trip point that the printer
uses to determine if the printer is out of paper. The default value for "n"
is set to 168 at the factory.
690 n Set Darkness Level: Sets the printer darkness or contrast level used but
the printer. The value for "n" is a range from 1 to 100 with 100 being the
darkest setting.
720 n Enable Power Up Script: A value of 1 enables the power up script
selected by the ^D567 command to be the power up script.
721 n Enable Status After Print: A value of 1 causes the printer to report its
status automatically after print.
723 n1,n2 Enable Auto TOF and Autoload on Power Up: The value for n1
determines if the printer will automatically perform and Auto TOF on
power up if set to a 1. The n2 parameter controls the autoload function of
6-12 LDS2 Programming Manual - 880019-0202