Microcom LDS2 Programming Manual page 106

^D VALUE COMMAND
340 n1,2,3 Save File: Command used to save files into the printer. The parameters
for the command include the name, size, and comment. Only the name is
required if sending a zip file. File types included graphics, scalable fonts,
and bitmapped fonts.
341 n List Files: Command used to list the stored in the printer.
File types for n"
1 – list all file types
2 – list graphic files
4 – list font files
5 – list script files
342 n Delete Files: Command used to delete files stored in the printer.
The asterisk (*) character may be used as a wildcard
Example:
*x - would delete files ending in x
x* - would delete files starting with x
x*y - would delete files starting with x and ending with y
*x* - would delete file containing x anywhere in the file
343 n List Script File: Command used to list the contents of a stored script file
to the active port. The value "n" is the filename.
350 n Load Script File: Command used to load and execute a saved script file.
The value for "n" is the name of the stored script file.
360 ? List Memory Available: Command lists the available RAM and Flash
memory.
365 ? List Status Commands: Command generate a list through the active port
that displays the status command messages available in Byte and Text
form.
390 1 Reset Command: Command used to reset the printer. This command
operates like power cycle to the printer and will cause the printer to
reboot.
391 1 Restore Configuration Defaults: Command sets configuration command
default values.
392 1 Restore Property Defaults: Command sets the property command to
their default values.
501 n Select Language Mode:
506 n Select Cutter Type: Selects the cutter type installed on the printer; n= 0
none, 1 guillotine, 2 rotary, 3 Microcom cutter.
LDS2 Programming Manual - 880019-0202 6-7